Pfister F-538-5LCS User Manual download pdf (Page 4)

ENGLISH

12 WATER SUPPLY CONNECTIONS

Gently separate hot and cold Faucet Inlets (12B), approximately three inches apart.

Connect water Supply Lines (12A) to Faucet Inlets (12B). Hot water supply line goes

to hot inlet ﬁ tting indicated by red tag (12C). (Supply lines not included). Follow

manufacturer’s instructions when installing supply lines.

13 SECURING INLET LINES

Do not cross Pullout Hose Connection (13A) with Inlet Supply Tubes (13B) to avoid

binding, jamming and interference with the movement of the Pullout Hose (13A).

14 UNIT START UP

Turn on hot and cold water supplies, and check for leaks above and below the sink

15 FLUSHING

To prevent damage to the internal parts of your faucet from debris that may have collected

in the water lines, it will be necessary to ﬂ ush the faucet. Lift the faucet handle (15A) up

to the full on position. Run water for one minute. Repeat in hot and cold positions.

Note: For valve functions (see step 18).

11 PULL-OUT HOSE ATTACHMENT

From underneath sink, push Quick Connector (11A), located on the end of the Pull-

Out Hose (11B) ﬁ rmly upward onto the Receiving Tube (11C), until unable to push any

further. Pull down on the Quick Connector (11A). If the housing and the Inner Collet

(11D) separate slightly but do not pull off, the Receiving Tube (11C) quick connect is

secure.

HOT

COLD

11A

12A

13B

11B

11C

11A

11C

11D

11A

11C

12A

12B

12C

12B

13B

13A

15A

1 2 3 4 5 6 7 8 9 ... 17 18

No comments

Pfister F-538-5LCS User Manual Page 4