Pfister F-049-ST0K Installation Guide Page 5

  • Download
  • Add to my manuals
  • Print
  • Page
    / 14
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 4
ENGLISH
ENGLISH
14
15
17
FAUCET FUNCTIONS
MAINTENANCE & CARE
16
CAUTION: Maintenance
DISASSEMBLY
1. Replacement parts may be available at the store where you purchased
your faucet.
2. When replacement parts are not available, please write or call Price Pfister
Consumer Service.
3. Always turn off water and relieve pressure before working on your
faucet.
NOTE: Trim Care
Cleaning Instructions:
For all Handles and decorative finishes, use only a soft damp cloth
to clean and shine. Use of polish, detergents, abrasive cleaners,
organic solvents or acid may cause damage. Use of other than
a soft damp cloth will nullify our warranty!
Special Trim:
Trim products which contain Porcelain or other similar substance
are not acceptable for public areas or Commercial use. Installation
of Said Trim is at Users Risk!
1–800–PFAUCET (1–800–732–8238)
For Toll-Free Pfaucet information call
1–800–PFAUCET (1–800–732–8238)
or visit www.pricepfister.com
• Installation Support
• Care and Warranty Information
14 UNIT START UP
Turn on hot and cold water supplies, and check for leaks above and below the sink.
15 FAUCET FUNCTION
COLD valve: close-counterclockwise, open-clockwise; HOT valve: close-clockwise,
open-counterclockwise.
Note: Flush faucet before turning on valve (see step 16).
16 FLUSHING & AERATOR CLEANING
After installation is complete, remove Aerator Housing (16A). Turn Valves (16B) on
and allow both hot and cold water to run for at least one minute each. While water is
running, check for leaks. To clean the aerator, disassemble Aerator Housing (16A) by
separating the Aerator Shell (16C), Basket (16D), and Washer (16E). Once parts have
been cleaned, reassemble by reversing steps.
17 VALVE CARTRIDGE REMOVAL
Turn off water supplies and relieve pressure before working on your faucet (see
step 2). With Valves in “Closed” position, unscrew Fastener (17A) and remove Handle
(17B) from Valve Stem (17C). Remove Handles Valve Flange (17D) and Plastic Nut
(17E) unscrew Retainer Nut (17F) by turning it counter-clockwise and lift out Cartridge
Assembly (17G) and inspect. Replace parts as necessary.
5
HOT
OPEN
OPEN
COLD
16A
16E
16D
16C
16B
17A
17B
17E
17D
17F
17C
17G
Page view 4
1 2 3 4 5 6 7 8 9 10 ... 13 14

Comments to this Manuals

No comments