Pfister GT72YP2C Installation Guide download pdf (Page 3)

ENGLISH

7 CONTROL BODY INSTALLATION

Place a bead of plumber’s putty in the groove along the bottom outer edge of Seal Ring

(7A). Place Seal Ring (7A) under base of Control Body (7B). From above sink, insert

Threaded Shank (7C) and Tubing (7D) through other side hole of sink.

8 SECURING CONTROL BODY

From underneath sink, place Round Washer (8A), and Mounting Nut (8B) onto Mounting

Shank (8C). Tighten loosely, make sure Handle (8D) swings equally in both directions.

Tighten Valve Body rmly to sink.

9 HOSE ATTACHMENT

From underneath sink, push Connector (9A), located on the end of Hose (9B) rmly

upward onto the Inlet Tube (9C), until unable to push any further. Pull down on Connector

(9A). If the housing and the Inner Collet (9D) separate slightly but do not pull off, the

Inlet Tube (9C) connection is secure.

To remove the quick connect attachment: Push up on Connector (9A). Holding Inner

Collet (9D) in place, pull downward on Connector (9A) until Inlet Tube (9C) is free.

10 WATER SUPPLY CONNECTIONS

Gently separate hot and cold supply tubes (10A), approximately three inches apart.

Connect water Supply Lines (10C) to Faucet Inlets (10B). Hot water supply line goes

to hot inlet tting indicated by red tag (10D). (Supply lines not included). Follow

manufacturer’s instructions when installing supply lines.

11 UNIT START UP

Turn on hot and cold water supplies, and check for leaks above and below the sink

10A

HOT

COLD

10A

10B

10C

10B

10D

10C

1 2 3 4 5 6 7 8 ... 11 12

No comments

Pfister GT72YP2C Installation Guide Page 3