Pfister GT72YP2C Installation Guide download pdf (Page 4)

ENGLISH

MAINTENANCE & CARE

FAUCET FUNCTIONS

CAUTION: Maintenance

DISASSEMBLY

1. Replacement parts may be available at the store where you purchased your faucet.

2. When replacement parts are not available, please write or call Price Pster Consumer

Service.

3. Always turn off water and relieve pressure before working on your faucet.

NOTE: Trim Care

Cleaning Instructions:

For all Handles and decorative nishes, use only a soft damp cloth to

clean and shine. Use of polish, detergents, abrasive cleaners, organic

solvents or acid may cause damage. Use of other than a soft damp

cloth will nullify our warranty!

Special Trim:

Trim products which contain Porcelain or other similar substance are

not acceptable for public areas or Commercial use. Installation of Said

Trim is at Users Risk!

1–800–PFAUCET (1–800–732–8238)

For Toll-Free Pfaucet information call

1–800–PFAUCET (1–800–732–8238)

or visit www.pricepster.com

• Installation Support

• Care and Warranty Information

13 VALVE FUNCTION

By lifting Lever Handle (13A) up, the valve will be activated allowing water to ow. The

water ow will increase by continuing to lift up Lever Handle (13A). By rotating Lever

Handle (13A) counterclockwise, the water temperature will decreased to full cold. By

rotating Lever Handle (13A) clockwise, the water temperature will increased to full

hot.

Note: Flush faucet before turning on valve (see step 14).

14 FLUSHING & AERATOR CLEANING

After installation is complete, remove Aerator Housing (14A). Turn Valve (14B) on

and allow both hot and cold water to run for at least one minute each. While water is

running, check for leaks. To clean the aerator, disassemble Aerator Housing (14A) by

separating the Aerator Shell (14C), Basket (14D), and Washer (14E). Once parts have

been cleaned, reassemble by reversing steps.

15 CARTRIDGE REPLACEMENT & HANDLE REMOVAL

Turn off water supplies and relieve pressure before working on your faucet.

Using a

” Allen wrench, loosen Set Screw (15A) and remove Handle (15B).

Remove

Dome Cap (15C) and Retainer Nut (15D) by unscrewing counterclockwise. Carefully remove

Cartridge (15E) by pulling it straight up and out. Inspect and replace as necessary.

Reassemble faucet by reversing steps.

12 SPOUT FUNCTION

Spout (12A) can be rotated around the Faucet Body in any direction.

HOT COLD

15A

13A

14A

13A

14B

14E

14D

14C

15B

15C

15D

15E

12A

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Pfister GT72YP2C Installation Guide Page 4

Comments to this Manuals

Related products and manuals for Faucets Pfister GT72YP2C